I took a look at the TripleVision system on your 2009 Tiffin Allegro Bus MH, and the Rear View Safety Backup Monitor # RVS-6137Q that you mentioned, and it will actually not work with your current system, unfortunately.
This monitor is only designed to work with RVS branded cameras, and is not compatible with TripleVision branded cameras.
However, the best solution as I see it, is to upgrade your current system.
A great option that utilizes the # RVS-6137Q monitor that you were looking... view full answer...
The sleeve or sheathing is part of the cord, not the plug so even if you were to just replace the plug using something like the Mighty Cord Replacement Hardwire RV Plug part # A10-P50VP you would still have exposed wires. Therefore, it would be best if you replace the entire power cord using the Mighty Cord RV Power Cord part # A10-5036EDBK which will offer much better protection as a sealed unit. view full answer...
It sounds like you have Fan-Tastic Vent Roof Vent 801250, which has reverse flow, a 3-speed fan and no rain detector. If this is your fan you need the Replacement Fan Motor Assembly Kit for Fan-Tastic Vent Roof Vent Fans # FVK8017-00, which replaces the bow-tie bracket, motor, and blade for your vent. view full answer...
For your 2017 Tiffin Allegro Bus Motorhome I would recommend Adco Tyre Gard RV Wheel Covers - Designer Series - 43" to 45" - Tan - Qty 4 Item # 290-3966 but I've also attached a link to our page that has some other options that will fit with additional colors for your personal preference. view full answer...
Thank you so much for all of the info!
I reached out to my contact at Lippert and he said that with how old your setup is you're going to be better off going with an entire replacement kit because if you just replace one component right now then you'll likely need to upgrade the other component soon.
If your 2002 Allegro Bus has a single step then the kit you need is part # LC379769, but if it has a double step then the kit you need it part # LC379145. view full answer...
I do have some weld-on options for you as I unfortunately do not have any custom fit bolt on options and I cannot look at the detailed specs for your 2022 Tiffin Allegro Bus 45 OPP Motorhome. We have 2 sets of the Curt Class 5 receivers with either a 44" or 62" wide receiver tube which are all rated for up to 20,000lbs trailer weight and 2,000lbs tongue weight. You will need to select the correct width based on your frame and the amount of drop you will need to clear any rear fascia panels.... view full answer...
You're correct, the Replacement Gear Pack for Lippert RV Slide-outs w/2-1/2" x 2-1/2" Arms # LC123356 uses a 15 tooth gear which is only going to work with Lippert slide outs made after October of 2013. With your motorhome being a 2010, you'd need to use the 18 tooth gear # LC122739 instead. view full answer...
If the Workhorse chassis on your 2003 Tiffin Allegro is a P30, P32, or P3500 then you will want to use the Roadmaster Reflex Steering Stabilizer # RM-RSSCP30, but if you have a W20 or W22 you will want the Roadmaster Reflex Steering Stabilizer # RM-RBK13-RSSA instead.
Let me know if you have a different chassis and I can help you find a different solution for a better ride. view full answer...
The part number for your Kwikee steps' control board is going to be 90950600 and the correct replacement part from Lippert for that control board is the # LC379606.
If you also need the motor or gear box and linkage, those parts are also available and listed below in case you are seeking those replacement parts as well.
Replacement Motor with Mounting Plate for Kwikee Electric RV Steps # LC379608
Replacement Gear Box and A Linkage for Kwikee Electric RV Steps # LC379160
Motor Upgrade... view full answer...
To install the Tekonsha Prodigy P3 Trailer Brake Controller # 90195 on your 2013 Tiffin Allegro Bus you will need to hardwire it in as there is not a port that allows it to plug in.
We have previously confirmed with Tiffin that there will be four wires under your driver's side dash that have butt conectors on them, and you will use these to wire in the Prodigy brake controller. The wires from the Prodigy are going to be Black for power, Blue for brake controller output, Red for stop light... view full answer...
The tire pressure sensor setup of your Honda CR-V would not interfere with the TST TPMS for RVs # TST-507-RV-4-C. The frequency of this kit would not be affected by anything on your CR-V. view full answer...
We have the Lippert part number they said you'd need with the part # LC427247 which would be your best option to get everything fixed on your setup as simply as possible. We do not have just the plate and rocker arm like you asked about. view full answer...
I have your solution, the Replacement Motor for Kwikee Electric RV Steps - 12V # LC379147 will replace your motor on your Kwikee 41 and 40 series steps. Like the Kwikee Electric RV Step Complete Assembly - Double - 40 Series - 24" Wide # LC3726892. view full answer...
Yes, as long as you strategically place the signal booster of the TST Tire Pressure Monitor System part # TST-507-RV-4-C as forward as you can in the trailer the monitor in your motorhome would be in range and would work great. view full answer...
I recommend replacing units with the Advent Air RV Air Conditioner w/ Air Distribution Box and Start Capacitor - 13,500 Btu - White # ACM135C.
Or if you want a heat strip go with the Advent Air RV Air Conditioner w/ Air Distribution Box, Start Capacitor, and Heat Strip - 13,500 Btu # ACM135CH.
Theses are the same unit one just comes with a heat strip. They will replace any not ducted AC unit on an RV.
If you have a ducted system you can use the Advent Air RV Air Conditioner - 13,500... view full answer...
I may have a solution for you, but without knowing exactly what type of awning this is I cannot confirm this will work. However, we do carry 2 awning end caps for Lippert/Solera awnings that I recommend checking out and seeing if they're the same as your existing end caps. I've listed and linked these parts below, but neither one unfortunately comes in gray:
Replacement Endcap for Solera Power Awnings - Black - Qty 1
Item # LC423751
Replacement Endcap for Solera Power Awnings - White... view full answer...
The Replacement Lens for Gustafson 3" Recessed RV Puck Light part # 277-000393 is made of plastic, not glass and it features a press-in installation. view full answer...
The range of the Curt Echo Wireless Trailer Brake Controller part # C51180 is 50' so it will work just fine on a 45' diesel pusher motorhome. I have spoken with Curt in the past about this very same question and they said that there are plenty of customers who use this brake controller on their diesel pusher motorhome without issue. The only other wireless brake controller we offer is the Autowbrake Electric Brake Controller part # 3430001 which installs completely on the trailer. view full answer...
Thank you for the pictures of your wheels, based on seeing what you have the Aluminum HWT part # AM22691 is the replacement you need. view full answer...
The overall diameter for 295/80R22.5 would be just over 41" so I recommend the SnapRing TireSavers Tire Covers - 40" to 42" Diameter - Black Vinyl # ST7005BK. These tire covers have an internal ring that allows them to easily expand to fit over your tires and "snap" right back for a snug fit.
I've attached a short video below where I'll walk you through just how easy these are to use. view full answer...